Paradyne 9261 Installation Instructions Manual page 7

Installing the T1 NAM
In the 2- and 5-slot housings, the NAM is always installed in Slot 01. In the access
carrier, the NAM can be installed in any slot.
!
WARNING:
Do NOT remove any jumpers located on the battery. To do so can cause
non-volatile memory loss. Should a jumper become separated from the
battery, contact your service representative immediately.
CAUTION:
Be sure that you install the NAM in the correct slot so that it mates with its
matching I/O card. Otherwise, you could damage your card.
1. Remove the housing's bezel, if applicable. See the housing installation instructions
for information.
2. Remove the NAM from the shipping box. Handle only by the top and bottom edges
to avoid damaging the card.
3. At the front of the housing, align the NAM with the upper and lower tracks of the
appropriate slot.
2-Slot
Ejector
Latches
4. Slide the NAM into the tracks until the it seats with the midplane connectors.
Be careful not to force the card or bend any pins.
5. Close both the upper and lower ejector latches to lock the NAM in place, then
tighten the captive screws on the ejector latches.
6. Replace the housing's bezel, if applicable.
5-Slot
Ejector
Latches
Front View
7
Access Carrier
Ejector
Latches
98-15750-01