Table of Contents
Advertisement
Installing the Power Supply and Cord
Before performing any installation procedures, please refer to the
Instructions
on page 20.
Procedure
1. Insert the power cord's plug into the POWER jack.
Grounded
Power
Outlet
System
FT1/T1
2. Plug the power supply into the grounded power outlet and check the LEDs.
If any LEDs light, you have power. If not, refer to Troubleshooting in the User's
Guide for possible explanations.
3. Insert the self-mounting tie wrap in the leftmost hole (hole with a dark circle around
it) until it snaps securely into place. The tie wrap provides strain relief for the power
cord.
4. Loop the tie wrap around the power cord, thread it through the hole at the base of
the wrap, and pull it snugly around the cord.
ETHERNET
COM
POWER
7123 SNMP DSU/CSU
System
Network
NET
P
O
R
T
Port
01-17032
5
Important Safety
Advertisement
Table of Contents
