Table of Contents
Advertisement
Connecting to the DTE
Procedure
1. Connect one end of the DTE's cable to the user data port.
2. Plug the other end of the cable into the DTE.
3. Tighten the screws on each side of the connector to secure the cable.
COM
POWER
4. Verify that the Port OK LED is on. If it is, the port is set up correctly and it is
operational. If not, make sure both ends of the cable are properly seated and
secured.
5. Check Health and Status messages in the left column of the System and Test
Status screen for messages.
Main Menu
— If System Operational appears, the port interface is set up correctly and
is operational.
— If not, refer to Status Information in Operation and Maintenance of the User's
Guide.
NOTE:
When any error conditions are detected, a status message appears along the
bottom right corner of the screen.
ETHERNET
P
O
R
T
DTE
Status
System and Test Status
NET
00-16689
8
Advertisement
Table of Contents
