Connecting to the Network
Procedure
1. Insert the 8-pin connector of the RJ48C network cable into the network interface.
2. Insert the other end of the cable into the RJ48C modular jack.
COM
POWER
3. Verify that the Network signal (SIG) LED is green. If so, the network interface is set
up correctly and is operational. If not, make sure both ends of the network cable are
properly seated.
4. Check Health and Status messages in the left column of the System and Test
Status screen.
Main Menu
ETHERNET
P
0
R
T
Status
System and Test Status
RJ48C
Jack
NET
00-16686
9