Power Supply - Paradyne 9000 Series Installation Instructions Manual

Installing in a Cabinet/Rack without Threaded Screw Holes
1. Slip a Speed Nut into the 3rd, 9th and 16th rail holes on the left side of the carrier,
and into the 3rd, 12th and 16th holes on the right side of the carrier. Align the hole
of the Speed Nuts with the hole in the rails.
2. Place the access carrier against the front rail of the cabinet, allowing the installed
machine screws to pass through the keyholes.
9th Hole
Front of 19-Inch Carrier Cabinet
3. Install the remaining machine screws at the top and bottom on both sides of the
brackets, then tighten them.

Power Supply

The DC power supply is designed and approved for – 48 VDC power systems. The
access carrier obtains low-voltage power from the power supply.
The power supply, with its I/O card, is already installed in your access carrier.
You can also order an additional power supply for backup.
The power receptacle is part of the power I/O card.
Mounting
Front Rail
Bracket
Speed Nut
Screw
496-15132
5