Body Solid GAR50 Assembly Instructions & Owner's Manual page 10

S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 2D. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
2A. Attach Foam Roller Holders (F) to Upright (C) using:
3 - (#2) M10x70mm Hex Head Bolt
6 - (#4) M10 Flat Washer
3 - (#5) M10 Nylon Lock Nut
2B. Attach Ball Holders (D) to Upright (C) using:
2 - (#1) M10x75mm Hex Head Bolt
4 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
2C. Attach Hooks (G) to Upright (C) using:
2 - (#1) M10x75mm Hex Head Bolt
4 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
2D. Attach Top Ball Holders (H) to Upright (C) using:
2 - (#1) M10x75mm Hex Head Bolt
4 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
10