Table of Contents
Advertisement
OPERATING AND MAINTENANCE MANUAL FOR TIER 4 SNOW
BLOWER MODELS: RPM215, RPM217, RPM220/36R, RPM40R,
RPM48R/52R AND HS300
5 Section E - Wireless System Operation
The wireless control system has been designed to keep the same operation as if it would be controlled
with a standard cable. Please refer to Section A of your operation and maintenance manual for a
complete description of each snow blower function. This page is dedicated to the features of the wireless
system only.
Starting the Engine
1. The controller will not start the engine if one of the following conditions applies:
• A communication error with the engine or controller is detected.
• The engine stop light is ON.
• The snow blower clutch is engaged.
• The snow blower engine is already running.
2. Turn the wireless system on by turning the green ignition switch on the snow blower.
3. Turn the ignition switch to the
just before the operation screen. Check if any errors are detected. If the snow blower is equipped
with heating elements, wait until the WTS light turns off.
4. Black and White display: turn the key to the
is running, release the key.
5. Color display: press and hold the
OK
button.
6. Check all gauges and make sure everything is within normal operation range.
Pre-Operation Test
At the start of each work shift, or when a new operator takes control of the snow blower, the operator
must test each function and the emergency stop button as well.
Loss of Communication
If communication is lost between the modules, the snow blower will stop. To restore communication,
you must turn the ignition switch to the
come up with the wireless system, reinstall and use the cable supplied with the unit until the
system has been troubleshot.
Display Configuration Menu
You must connect the loader cable to log on to the configuration menu as it cannot be accessed through
the wireless system.
Shutting Down the Engine
To shut down the engine, place the key switch to the
the green ignition switch on the snow blower is turned off.
S00-OME-T4 rev 7
ON
position. On the display, the logo screen will appear for 5 seconds,
START
OK
button on the display. Once the engine is running, release the
OFF
position and then to the
OFF
position to crank the engine. Once the engine
ON
position. Shall any issues
position. When leaving the unit, make sure
Page 97
Advertisement
Table of Contents
