Table of Contents
Advertisement
OPERATING AND MAINTENANCE MANUAL FOR TIER 4 SNOW
BLOWER MODELS: RPM215, RPM217, RPM220/36R, RPM40R,
RPM48R/52R AND HS300
1.1.3
Controls
1. IGNITION SWITCH:
procedure, described at page 60, before starting the snow blower.
NOTE:
The controller's programming prevents the engine from starting if an emergency status is active.
Furthermore, if the clutch is engaged, it must be disengaged manually before starting.
OFF
POSITION: Engine off. Remove or insert the key at this position.
ACC.
POSITION: Not used.
ON
POSITION: Normal running position after the engine is started. This
position will activate all the commands and control features.
START
POSITON: Used to start the engine. The engine will crank until you release the key and the key
will return to the
ON
position when released. The controller disables the start command if the engine is
already running.
2. EMERGENCY STOP BUTTON:
the engine during an emergency. You only need to push the button to
stop the engine. To re-start the system, turn the emergency button
clockwise and re-start the snow blower. When this button is applied,
the power supply for both engine and control is cut off. The display
shows a communication error.
3. MULTIPURPOSE JOYSTICK (4 buttons standard):
arm allows controlling all the functions of your snow blower. The
button functions can be configured on the snow blower screen.
(Details on page 27 and 28). Refer to following pages for more details
on joystick configuration.
S00-OME-T4 rev 7
This ignition switch controls the electrical system. Read the start engine
This button allows shutting down
Ignition Switch positions
The shifting
Figure A5: Standard Joystick.
Figure A4
Page 26
Advertisement
Table of Contents
