Table of Contents
Advertisement
OPERATING AND MAINTENANCE MANUAL FOR TIER 4 SNOW
BLOWER MODELS: RPM215, RPM217, RPM220/36R, RPM40R,
RPM48R/52R AND HS300
1.3 Start-up and Operating Instructions
Operating Instructions for the Snow Blower attached to the Loader
Loader operation with the snow blower attached: Refer to the loader operation manual for optimal
travel conditions, stability and safety when using the loader with the snow blower attached.
To attach and detach the snow blower to the loader: Refer to the quick attach installation and
operation manual for instructions.
1.3.1
Pre-Start Checks
It is good practice to inspect the machine before operation. Check for such things as loose
bolts or fittings, leaking of chafed hoses, protection guard, etc. Thus, latent problems can be caught
and corrected before they become serious.
Check fluid levels.
Check the quick coupler.
Make sure that there is nothing in the snow blower mechanism (remove the snow from the
bin and the drum); ensure that the fan and augers are rotating freely (by hand).
1.3.2
Starting the Engine
1. Do the « Pre-Start Check » as listed above.
2. Use the loader or backhoe loader horn as a warning before starting. Those exposed should have
time to leave the danger zone.
3. The controller won't start the engine if one of the following conditions occurs.
•
A communication error with the engine or controller is detected.
•
The engine stop light is ON.
•
The snow blower clutch is engaged.
•
The snow blower engine is already running.
4. Turn the ignition switch to the
just before the operation screen. Check if any errors are detected. If the snow blower is equipped
with heating elements, wait until the light goes off.
5. Turn the key to the
key.
6. Check all gauges and make sure everything is within normal operation range.
S00-OME-T4 rev 7
ON
position. On the display, the logo screen will appear for 5 seconds,
START
position to crank the engine. Once the engine is running, release the
Page 60
Advertisement
Table of Contents
