Table of Contents
Advertisement
OPERATING AND MAINTENANCE MANUAL FOR TIER 4 SNOW
BLOWER MODELS: RPM215, RPM217, RPM220/36R, RPM40R,
RPM48R/52R AND HS300
OUTDOOR STORAGE
Whenever the blower is used at a temperature above freezing (0° Celsius, 32° Fahrenheit) in heavy
wet snow, it is imperative to remove any accumulated snow and ice that is stuck in the blower
workings prior to overnight outdoor storage (or any inactive period longer than 2 hours). This will help
avoid mechanical freeze-up if the weather turns cold.
The same approach is suggested even if the blower is used in colder temperatures. Remove
accumulated snow and ice prior to outdoor storage during any cold weather period
1.3.6
Clutch Control
To engage the clutch, the operator must first press
clutch menu. When this menu is activated, the engagement of the clutch is done by pushing
When this function is activated, the clutch control light will turn and stay on to signal that the clutch is
engaged. If the emergency light signals a clutch problem, stop the engine immediately to prevent any
damage.
To disengage the clutch, press
button
2, the clutch light will vary until the clutch is disengaged.
The vehicle's rpm must remain under 850rpm for the clutch to be engaged and disengaged.
Moreover, no emergency warnings should be on as it will automatically disengage the clutch.
Operator should check daily if there is no pushing or pulling force on the hand lever after clutch has
been engaged or disengaged.
1.3.7
Emergency Clutch Control (manual clutch lever)
Snow blowers are equipped with manual clutch levers. With this lever, the clutch can be engaged or
disengaged manually. Manual commands are only allowed when the clutch sensor is unplugged, which
can be done by removing the connector from the bottom of the angle sensor. It must be unplugged
before any attempt to move the lever is made. This type of engagement should only be used in
EMERGENCY
situations.
The clutch will have to be manually disengaged when the snow blower is stopped with clutch still
engaged. The snow blower cannot be started when the clutch is engaged.
S00-OME-T4 rev 7
button 4
button 4
of the screen control in order to display the menu, then press
WARNING!
of the screen control in order to display the
button
3.
Page 64
Advertisement
Table of Contents
