Panasonic LUMIX H-FS14140-S Service Training Manual page 17

6.2.2.5. Installation of the 1st Lens Holder and
the Cam Barrel
1. Align phase mark ( ) and rotate the Cam Barrel Unit
clockwise when you watch it from back.
6.2.2.6. Installation of the Wave Washer
1. Install the Wave Washer.
6.2.2.7. Installation of the Ring Mount Base
Unit and the Zoom Drive Pin
1. Install the Ring Mount Base.
2. Tighten 3 screws (F) in numerical order
by using the torque driver with specified torque.
Screw Order
Torque 10 ± 1 N cm
3. Install the Zoom Drive Pin.
4. Tighten 2 screws (G) in numerical order
by using the torque driver with specified torque.
Screw Order
Torque
6.2.2.8. Installation of the Lens P.C.B. Unit and
the Lens Mount Contact Unit
1. Connect FPC of Lens Mount Connect Unit to connector.
2. Installation the Lens P.C.B. Unit and
the Lens Mount Connect Unit.
3. Connect FPCs to 4 connectors of the Lens P.C.B. Unit.
1
10 ± 1 N cm