Table of Contents
Advertisement
Step 3 Scene-by-Scene Editing, Creating/Displaying Titles
Scene-by-Scene Editing — To Edit Scenes One by One
What is Scene-by-Scene Editing?
In scene-by-scene editing, you designate only the IN point of
Locate the start point of the
the scene. Then you select and connect the scenes one by
tape to be recorded, using the
one while viewing the picture.
tape transport buttons and jog/
shuttle dial of the RECORDER
section, and set the recorder to
the recording pause mode.
Tape transport direction
Lights only in the case
of the Connection 1.
Press the VIDEO EDIT button.
The VIDEO EDIT indication lights and
the RM-E700 starts scene-by-scene
editing. The player rewinds the tape
about 15 seconds before the IN point
;
| .
| a
and starts playback. The recorder
a
:
nm J
qn
starts recording from the IN point.
ar
WU
Os
eam
Edited tape
(in the recorder)
Press the VIDEO EDIT button at
the end of the desired scene.
The VIDEO EDIT indication turns off.
The player continues playback for
about 2 seconds and enters the
playback pause mode. The recorder
immediately enters the recording
Pause mode.
The END MODE selector at the rear
does not work for scene-by-scene
editing.
Tape transport direction
Operation
Turn the power on this unit.
The current counter of the player
appears.
oP
Repeat from step 2 to 5.
nn
'
thtyOw
t
Ts
{+
Current counter of the player
To stop scene-by-scene editing
Press the VIDEO EDIT button again, or the &@ STOP button
of the PLAYER section.
Locate the start point of the
desired scene (iN point), using
the tape transport buttons and
jog/shuttle dial of the PLAYER
section, and set the player to
the playback pause mode.
30
31
Advertisement
Table of Contents
