Table of Contents
Advertisement
Use this connection when you have a Sony recorder
with the CONTROL S input jack only. After connection,
set the switches at the rear of the RM-E700. When
your recorder has the CONTROL S input jack and a
CONTROL L, REMOTE, or LANC @ jack, we
recommend using "Connection 1".
1
Connect the RM-E700
Recorder
TV or monitor
Connect the TV (or monitor)
to the recorder.
f) to CONTROL § input
CONTROL S/GPI
OUT connecting
cable (supplied)
and the recorder.
to audio/video input
Connecting cable
(not supplied, page 54)
video (yellow)
audio L (white)
audio R (red)
ant)
b
Connecting cable
(not supplied, page 54)
audio R (red)
audio L (white)
video (yellow)
4
Set the switches at the rear.
Other switches may be at any position.
RECORDER section
VTR2
VTRI
VTR3
the same position as the recorder.
— Set to: VTR1 for ED Beta/Beta VCR; VT!
VTR3 for VHS VCR.
SONY
MEMORY
The command mode (VTR1, VTR2 or
COMMAND
VTR3) appears in the display window.
MODE
The figure on the right is when you set
Set to SONY.
R2 for 8mm VCR;
=a
ua
Connect the RM-E700 and the player.
to audio/video output
to CONTROL L, REMOTE
or LANC @
b
3
Connect the RM-E700 to the power source.
Do not turn on the power until you finish all the connection.
Doing so, may cause a matfunction.
CONTROL L connecting
cable (supplied)
AC-O04L
i
to DC IN 6V
i
fi
PLAYER section
When an infrared jog/shuttle remote control unit is not
Supplied, or it is not available on option to operate
A
8
your video equipment >
Setto A.
supplied, or it is available on option to operate your
video equipment. > Set to B.
Advertisement
Table of Contents
