Table of Contents
Advertisement
Inserting the Lithium Batteries
This unit uses two lithium batteries to keep the data for
program editing, the data for timing adjustment, and the
stored remote control signal of other manufacturer's video
equipment.
To remove the lithium batteries
Press the side of the battery in the direction indicated for
installation.
Notes on lithium battery
« Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately consult a
doctor.
Wipe the battery with a dry cloth to assure a good contact.
Be sure to observe the correct polarity when installing the
battery.
* Do not hold the battery with metallic tweezers, otherwise a
short-circuit may occur.
The lithium battery compartment is located at the bottom.
i
In step 4, make sure that the AC power adaptor is connected before turning on the power. Otherwise,
How
to insert
the lithium battery will be consumed quickly.
Open the cover of the lithium
WARNING
battery compartment.
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Lithium battery life
Approximately 1 year in normal operation.
When the lithium batteries become weak, the (J mark will
light in the display window. When this happens, replace
the battery with a Sony CR2025 lithium battery. Use of
another battery may present a risk of fire or explosion.
Insert the supplied two
CR2025 lithium batteries with
correct polarity.
Note
To keep the data, replace the lithium batteries with the AC
power adaptor connected. If you replace the lithium batteries
when the AC power adaptor is not connected, the data will
be erased. Also, when the lithium batteries are completely
discharged, the data will be erased. In this case, store them
again.
Close the cover.
Connect the supplied AC power adaptor to the DC IN 6V jack at the rear, and turn on the POWER
switch.
Check that the C1 mark does not appear in the display window.
Advertisement
Table of Contents
