Table of Contents
Advertisement
Caution
When the player is a video camera recorder or a video
When the player has the infrared beam detector:
recording or break off the tab.
TV or monitor
Connect the TV
(or monitor) to the recorder.
to CONTROL L, REMOTE
or LANC @
Connecting
Connecting cable
cable (not
(not supplied, page 54)
supplied, page 54) i,
hs
|
/
co
audio R (red)
}
(supplied)
to a wall outlet
Set to SONY.
RECORDER section
PLAYER section
When the recorder has the COMMAND MODE selector
~» Set to the same position as the recorder.
When the recorder does not have the COMMAND MODE
selector > Set to: VTR1 for ED Beta/Beta VCR; VTR2 for
8mm VCR; VTR3 for VHS VCR.
When an infrared jog/shuttle remote control unit is
not supplied, or it is not available on option to
The command mode (VTR1, VTR2
ie
7
operate your video equipment
Set to A.
of VTR3) appears in the display
window.
Note
SHUTTLE MODE
;
:
The figure on the right is
The RM-E700 cannot control the tape transport functions
When an infrared jog/ shuttle remote control unit is
when you set the COMMAND
which the recorder does not have, even though the RM-E700
supplied, or it is available on option to operate your
MODE selector to VTR3.
has those transport buttons.
video equipment — Set to B.
zt
Signal flow
Advertisement
Table of Contents
