Table of Contents
Advertisement
Program Editing—To Edit Scenes in Succession
The following indications appear during programming and
previewing. The error messages appear when the
programming was not performed correctly (page 52).
eres
Designate the IN point of the Cut.
During programming, lit until the IN point is designated.
During previewing, lit while the tape moves to the IN
point of the next Cut.
During programming, {it until the OUT
point is designated.
Hour
Minute
Second
During previewing, lit while the tape
moves from the IN point
to the OUT point.
© For
, See page 48.
Cut No.
Flashing during
programming
Frame*
Lit during previewing
* When the counter of the vieo equipment is a 4-digit counter,
the display becomes the 4-digit counter.
* Appears only when the player is a video equipment with the
RC time code recording function.
eyteieme
set to Programming Mode.
Turn on the power on this
unit.
The current counter of the player
appears.
oP
PGM
G.Gcu 1%
Current counter of the player
Locate the IN point of Cut 1
(1st Cut) using the tape
transport buttons and jog/
shuttle dial of the PLAYER
section, and set the player to
the playback pause mode at
the IN point.
More than about 15 seconds
(about 15 counts for the 4-digit
counter) of the counter reading is
necessary from the beginning of
the tape to the IN point.
Press the ENTRY button.
The IN point of Cut 1 has been
designated. In the display window,
CUT IN disappears and CUT OUT
lights. The RM-E700 now accepts
the designation of the Cut 1 OUT
point.
Locate the OUT point of Cut 1
using the tape transport
buttons and jog/shuttle dial
of the PLAYER section, and
set the player to the playback
Pause mode at the OUT point.
More than about 3 seconds (about
3 counts for the 4-digit counter) of
the counter reading is necessary
from the OUT point to the end of
the tape.
22
PI
Re a TET ee RT Ta
NT ee a Le
Press the PGM button.
The IN point of the previously
designated Cut t (when no
designation,
-) appears for
about 3 seconds, then the current
counter of the player appears. In
the display window, PGM flashes,
CUT IN and 01 light. The RM-E700
now accepts the designation of the
Cut 1 IN point.
lit Current count
lit
of the player
Press the ENTRY button.
The OUT point of Cut 1 has been
designated. In the display window,
CUT OUT disappears , CUT IN and
02 light. The RM-E700 now accepts
the designation of the Cut 2 IN
point.
it
Cut1 OUT
iit
point
Continued on next page
23
Advertisement
Table of Contents
