Table of Contents
Advertisement
Connection 4
Use this connection when you have another
manufacturer's recorder with an infrared remote
control unit. After connection, set the switches at the
rear of the RM-E700, and then store the tape
transport functions of the recorder's remote control
unit. For the store operation, see page 18.
TV or monitor
1
Connect the RM-E700 and the recorder.
~
=
Recorder
to audio/
to audio/video output
video input
Connect the TV (or monitor)
to the recorder.
to CONTROL L, REMOTE
or LANC @&
Connecting cable
Connecting cable
{not supplied, page 54)
(not supplied, page 54)
/
I
video (yellow)
audio R (red)
audio L (white)
audio L (white)
Do not turn on the power until you finish all the connections,
Doing so, may cause a malfunction.
AC-D4L
PP >
{supplied}
to a wall outlet
lJ
video (yellow)
cable (supplied)
to DC IN 6V
ii
4
Set the switches at the rear.
RECORDER section
PLAYER section
Other switches may be at any position.
When an infrared jog/shuttle remote control unit is
not supplied, or it is not available on option to
by pressing the pause button — Set to A.
by pressing the play button > Set to B
SHUTTLE MODE
;
;
by pressing the record button > Set to C.
When an infrared jog/shuttle remote control unit is
supplied, or it is available on option to operate your
video equipment — Set to B.
«>
Signal flow
You cannot use the jog/shuttle dial of the RECORDER section to
operate a video quipment of other manufacturers.
Continued on next page
Advertisement
Table of Contents
