Air Supply - Graco ProMix PD2K Installation Manual

Proportioner for automatic spray applications
Hide thumbs Also See for ProMix PD2K:
Table of Contents

Advertisement

Air Supply

Air Supply
Supply
Air
Air
Supply
Air Requirements
Requirements
Air
Air
Requirements
• Compressed
Compressed air
Compressed
air
air supply
supply pressure:
supply
(0.6–0.7 MPa, 6.0-7.0 bar).
Air hoses:
hoses: use grounded hoses that are correctly
• Air
Air
hoses:
sized for your system.
• Air
Air regulator
Air
regulator
regulator and
and bleed-type
and
bleed-type shutoff
bleed-type
in each air line to fluid supply equipment. Install
an additional shutoff valve upstream of all air line
accessories to isolate them for servicing.
Trapped air can cause a pump or dispense
valve to cycle unexpectedly, which could result
in serious injury from splashing or moving parts.
Use bleed-type shutoff valves.
To reduce the risk of fire and explosion if using
a Graco electrostatic gun, a shutoff valve must
be installed in the gun air line to shutoff the
atomizing and turbine air to the gun. Contact
your Graco distributor for information on air
shutoff valves for electrostatic applications.
Air Line
Line Filter
Filter for
for System
System Control
• Air
Air
Line
Filter
for
System
air regulator/filter 17M842 to provide clean and dry
air to system control solenoids.
Air Line
Line Filter
Filter for
for Atomizing
Atomizing Air:
• Air
Air
Line
Filter
for
Atomizing
to filter oil and water out of the air supply and help
avoid paint contamination.
See
Technical Specifications, page
filtration requirements.
28
pressure: 85-100 psi
pressure:
shutoff valve:
shutoff
valve: include
valve:
Control Air:
Air: Use supplied
Control
Air:
Air: Provided by others
Air:
55, for air
Air Connections
Connections
Air
Air
Connections
1. Tighten all system air and fluid line connections
as they may have loosened during shipment.
2. Connect the main air supply line to air
regulator/filter 17M842, and then to the main air
inlet (136). This air line supplies the solenoids,
valves, and pumps. Do not use this line to supply
the gun's atomizing air.
3. Connect a separate,
separate, dedicated,
separate,
line to the air inlet of the gun atomizing air.
Figure 17 Atomizing Air and Air Manifold Connections
Key
Key
Key
Connection
Connection
Connection
A
C
M
S
dedicated, clean air supply
dedicated,
Description
Description
Description
Air inlet
Air cutoff output
(plugged)
Exhaust muffler
Solvent cutoff output
(plugged)
332458M

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ac0500Ac1000Ac2000Ac2002Ac0502Ac1002

Table of Contents