Fluid Supply
Single Color
Color Connections
Connections
Single
Single
Color
Connections
NOTE:
NOTE: Check valves (J, L) are provided on the inlet
NOTE:
(K) and outlet (H) manifolds of each pump.
1. Connect the color supply line to the pump fluid
inlet fitting (S).
2. Connect the color outlet line to the pump fluid
outlet fitting (R).
3. Make the same connections on the catalyst side.
NOTE:
NOTE: For isocyanate catalyst materials, moisture
NOTE:
resistant hose is required to supply fluid to the system
and also as a fluid line between the pump and the
mix manifold.
Figure 18 Pump Inlet and Outlet Connections
30
Color Change
Change Connections
Connections
Color
Color
Change
Connections
If you are installing the color change accessory kit,
make the fluid connections as described in manual
333282.
Solvent
Solvent Connections
Solvent
Connections
Connections
1. Connect the solvent supply line for the resin to
the inlet fitting (17) for solvent flow switch 1 (FS1).
2. Connect the solvent supply line for the catalyst
to the inlet fitting (17) for solvent flow switch 2
(FS2).
3. Connect the solvent outlet line for the resin to
the solvent flow switch 1 (FS1) outlet fitting (74)
and then to the appropriate remote color change
valve.
4. Connect the solvent outlet line for the catalyst to
the solvent flow switch 2 (FS2) outlet fitting (74)
and then to the appropriate remote color change
valve.
Figure 19 Solvent Connections
332458M