System - Graco ProMix PD2K Installation Manual

Upgrade Software Software for
Upgrade Upgrade Software

System

System System
If upgrading your ProMix PD system to a PD3K+,
the software will need to be upgraded when starting
up the system. The PD3K+ software comes
on a black token with upgrade kit 26C416 (see
10. Upgrade Kit, page
Install Install Install the the PD3K+ the PD3K+ Upgrade PD3K+ Upgrade Token Upgrade
1. Shut off the PD2K power switch.
2. Remove the token access panel.
Figure 15 Remove Token Access Panel
332458M
for ProMix ProMix PD3K+ PD3K+
for ProMix PD3K+
24).
Token Token
Install the Display Module
3. Insert and press token (T) firmly into slot.
NOTE: There is no preferred orientation of the
NOTE: NOTE:
token.
Figure 16 Insert Token
4. Turn the power switch back on. The red indicator
light (L) will flash until the new firmware is
completely loaded.
5. Remove the token (T).
6. Replace the token access panel.
27