Installation; Reception Of Goods; Transportation And Storage - Salda AKU Operation, Installation & Maintenance Instructions

5. INSTALLATION

5.1.

RECEPTION OF GOODS

Each device is carefully checked before transportation. When receiving the goods, checking the devices for any damage made during transpor-
tation is recommended. If any damage to the unit is observed, immediately contact the representatives of a transport company. Please inform the
representative of the manufacturer, if any deviation of the device is noticed.
5.2.

TRANSPORTATION AND STORAGE

• All units are factory-packaged to withstand normal conditions of transportation.
• When unpacking, check the unit for any damage made during transportation. Installing the damaged units is not allowed!
• The packaging is used for protection purposes only!
• When unloading and storing the units, use suitable lifting equipment to avoid damage and injuries. Do not lift units by holding on power supply
cables, connection boxes, air extract or exhaust flanges. Avoid hits and shock overloads. Before installation, the units must be stored in a dry
room with relative air humidity not exceeding 70 % (at +20 °C) and with an average ambient temperature ranging between +5 °C and +30 °C.
The storage place must be protected against dirt and water.
• The units must be transported to the storage place or installation site using forklifts.
• The recommended storage period should not be longer than one year. In case of storing the units for a period longer than one year, checking
if the fan bearings and motor rotate without difficulty (turning the impeller by hand) and if the electric circuit insulation is not damaged or the
moisture has not accumulated must be performed before the installation of the unit.
[mm]
AKU 125 305
AKU 160 305
AKU 200 D 305
AKU 200 M 425
AKU 250 D 780
AKU 250 M 425
AKU 250 S 780
AKU 315 D 850
AKU 315 M
780
AKU 400 D 850
AKU 400 S
962
AKU EKO 125 330
AKU EKO 160 345
AKU EKO 200 430
AKU EKO 250 430
AKU EKO 315 760
AKU EKO 700X400 855
KF T120 160-4 L3 740
KF T120 180-4 L3 740
KF T120 200-4 L3 740
KF T120 225-4 L3 850
20 | EN
L W
Dimensions of a single package
H1 W1
[mm]
420
420
420
455
900
455
890
1050
890
1050
832
420
495
555
555
630
1070
540
540
540
600
H
L
Dimensions of a multi-package
L1 H2
[mm] [mm]
495 1900
495 1900
495 -
535 1900
765 -
535 -
765 -
900 -
765 -
900 -
957 -
500 1900
650 1900
705 2000
705 2000
660 -
840 -
550 -
550 -
550 -
650 -
H
W
transported packages
W2 L2
[mm] [mm]
800 1200
800 1200
- -
900 1200
- -
- -
- -
- -
- -
- -
- -
800 1200
800 1200
800 1200
800 1200
- -
- -
- -
- -
- -
- -
Max. number of
[PCS.]
20
20
1
16
1
1
1
1
1
1
1
16
9
8
8
1
1
1
1
1
1
FANS v2024.1