Possible Faults And Troubleshooting - Salda AKU Operation, Installation & Maintenance Instructions
Source: salda.lt/en, vetter-lufttechnik.de
Hide thumbs
Also See for AKU:
- Mounting and installation instruction (13 pages) ,
- Installation instruction (12 pages)
Table of Contents
Advertisement
10. POSSIBLE FAULTS AND TROUBLESHOOTING
FAILURE
The unit is not operating
44
| EN
CAUSE
No supply voltage
The protection device is off or a current
leakage relay is active (if installed by the
installer)
EXPLANATION/CORRECTIVE ACTIONS
Check whether the device is connected to the
power network.
Switch on only if the unit condition has been
evaluated by a qualified electrician. If the sys-
tem failed, the failure MUST BE rectified prior
to switching the system on.
FANS v2024.1
Advertisement
Table of Contents
