Connector #2
Pin
Signal name
14
+5V
15
GND
Link port connectors
On Matrox Odyssey XG, there are two link port connectors. These connectors
are standard 64-bit 33/66 MHz 3.3V PCI and 64-bit 66/100/133 MHz PCI-X
connectors. Their main use is to interconnect Matrox Odyssey XG boards with
Matrox Odyssey Xpro boards. However, you can use them to interconnect Matrox
Odyssey XG boards with a third-party or custom board. If you have intentions of
doing so, please contact your local Matrox Imaging representative, Matrox
Imaging sales office, or the Matrox Imaging Customer Support Group. This is
required to obtain information on how to interface with Matrox Odyssey XG
through software.
For electrical specifications, refer to PCISIG (www.pcisig.com) to buy the PCI
specification.
For a pinout of each link port connector, refer to your Matrox Odyssey Xpro
documentation.
Connectors on Matrox Odyssey XG
Pin
Signal name
C5
GND
C6
GND
27