Table of Contents
Advertisement
Electrical specifications
Matrox Odyssey XG
Operating voltage and current
Connectors on Matrox Odyssey XG
Besides the PCI-X edge connector, there are four interface connectors on the
Matrox Odyssey XG. On the bracket, there are two DVI-I connectors. On the
top edge of the board, there are two link port connectors.
DVI-I connectors
There are two DVI-I connectors on the Matrox Odyssey XG, located on the
bracket. They are used to connect the display board to display devices (for example,
a monitor or television). Connector #1 can be used to connect a single digital or
analog display. Connector #2 can connect up to two displays to the board, via the
DVI-TO-DVIBNCSV cable. The pinout for each connector is listed below.
Typical: 3.3 V, 2.75 A = 9.1 W
Typical: 5.0 V, 0.8 A = 4.0 W
Typical: 12.0 V, 0.3 A = 3.6 W
Total (typical) = 16.7 W
Connector #2
Connector #1
1
8
C1
9
17
24
C3
Electrical specifications
Bottom of card
C5,C6
C2
C4
25
Advertisement
Table of Contents
