Display Rotation; Display Intensity; Temperature Units; Resetting To Factory Defaults - Martin ERA 700 Performance IP User Manual

• When set to OFF, the fixture first goes into a warm-up sequence to warm up grease and bearings
when it is powered on after a period when it has not been in use and the ambient temperature has
been below freezing point. Mechanical effects are disabled until the fixture has warmed up to within
its operating temperature range. The warm-up time required will typically be 20 minutes at -20° C
(-4° F) and 40 minutes at -40° C (-40° F).
De-humidification
The fixture's DE-HUMIDIFY function reduces internal humidity, reducing the risk of condensation
buildup inside the fixture. It is possible for a certain amount of condensation to be visible behind the
front lens of an IP66-rated lighting fixture in certain environmental conditions, and this is not normally a
problem. However, if condensation becomes visible we recommend that you run a forced de-
humidifying sequence (see below) as soon as possible.
• When set to ON (the default setting), the fixture automatically detects excess humidity while it is
operating and runs a de-humidifying sequence before normal operation is available. This feature
can be useful when the fixture is placed in a humid environment with long standby periods.
• When set to OFF, automatic de-humidifying functionality is disabled.
You can run the de-humidifying sequence manually at any time using the SERVICE → FORCE DE-
HUMDIFY command. Note that normal operation is paused during the de-humidifying sequence.
If the fixture's DE-HUMIDIFY function begins to run constantly, there is probably a leak that is allowing
moisture to enter the fixture. Contact your Martin supplier for help.

Display rotation

To set the orientation of the control panel display:
1. Select DISPLAY → DISPLAY ROTATION and press ENTER.
2. Use the DOWN and UP buttons to select NORMAL (display in normal orientation) or ROTATE
180° (display inverted to make it easier to read if you install the fixture with the head hanging
vertically downwards).
3. Press ENTER to confirm your choice (or press MENU to exit without making a change).

Display intensity

To set the brightness of the control panel display:
1. Select DISPLAY → DISPLAY INTENSITY and press ENTER.
2. Use the DOWN and UP buttons to adjust the brightness of the display from 10% to 100%.
3. Press ENTER to confirm your choice (or press MENU to exit without making a change).

Temperature units

To set the fixture to display temperatures in degrees Celsius or Fahrenheit:
1. Select DISPLAY → TEMPERATURE UNIT and press ENTER.
2. Use the DOWN and UP buttons to select °C or °F.
3. Press ENTER to confirm your choice (or press MENU to exit without making a change).

Resetting to factory defaults

To reset the fixture to its factory default settings:
1. In the DEFAULT SETTINGS menu, select FACTORY DEFAULT and press ENTER to confirm.
2. Use the DOWN and UP buttons to select YES to erase any custom settings that you have
configured and reset the fixture to its factory default settings, or select NO.
3. Press ENTER to confirm your choice (or press MENU to exit without making a change).
Note that this does not affect the fixture's calibration settings.
18
®
Martin ERA 700 Performance IP User Manual Rev. D