Martin ERA 700 Performance IP User Manual page 24

can adjust the effect's position using that effect's DMX channel (8- or 16-bit) as follows:
• DMX value 0 = -5%
• DMX value 127/32767 = 0%
• DMX value 255/65535 = +5%.
4. Adjust the effect until it is in the required position (for example, adjust the zoom angle on each
fixture in the group until the angle on all fixtures is identical – this is the position that you will obtain
when you send DMX value 200).
5. Send a 'Store XXX calibration' command on the Control/Settings channel for each effect that you
adjust and hold that command for 5 seconds to activate. The new calibration offset is now stored in
memory.
6. When you have finished adjusting calibration offsets, send value 0 on the Control/Settings channel
and hold for 5 seconds to exit the DMX calibration procedure and return to normal DMX control.
Calibration offsets that are stored in memory are not affected by powering the fixture off and on or by
updating the fixture software.
Restoring default calibration offsets
If you want to delete all custom calibration offsets and return the offsets to their default values:
1. On the Control/Settings DMX channel, send a 'Reset all calibration values to factory defaults'
command and hold for 5 seconds.
2. The fixture will return all effects to their default calibration values.
Note that, If you have overwritten the factory default values by applying a SERVICE → CALIBRATION
→ LOAD DEFAULTS → SAVE command in the fixture's onboard control panel, the fixture will return to
the calibration values that were saved as the default values at that time. The SAVE command in the
fixture's control panel permanently replaces the factory default calibration settings with any custom
calibration settings that are applied at that time.
24
®
Martin ERA 700 Performance IP User Manual Rev. D