C
ONTROL
You set the address and personalities, read out data, and execute service utilities from the control panel.
Settings can also be changed remotely via the serial link with the Martin MP-2 uploader.
See also the control menu table starting on page 30.
Menu navigation
The DMX address and any error messages are displayed after the fixture resets. To enter the menu, press
[menu]. Use the [up] and [down] keys to move within the menu. To select a function or submenu, press
[enter]. To escape a function or menu, press [menu].
DMX Mode selection
The fixture has two DMX operating modes, 16-bit and 16-bit Extended. 16-bit Extended mode uses 17 DMX
channels, three more than the 14 DMX channels than standard 16-bit mode requires. 16-bit Extended mode
provides more precise control of the dimmer color, and focus settings. The DMX mode is selected using the
PSET option in the fixture control menu (see "Control menu" on page 30).
S E T T I N G T H E D M X M O D E
1 Apply power to the MAC 250 Krypton. Press [menu] to enter the main menu.
2 Select PSET using the [up] and [down] keys. Press [enter].
3 Select 16BT for standard 16-bit mode, or 16EX for 16-bit extended mode.Press [enter].
4 Press [menu] to return to the main menu.
DMX Address selection
For independent control, each fixture must be assigned its own address and non-overlapping control
channels. Two MAC 250 Kryptons can share the same address if they are to respond identically: they will
receive the same instructions and individual control will not be possible.
S E T T I N G T H E D M X A D D R E S S
1 Apply power to the MAC 250 Krypton. Press [menu] to enter the main menu.
2 Select AddR using the [up] and [down] keys. Press [enter].
3 Select an address (start channel) from 1 to 500 using the [up] and [down] keys. Press [enter]. Press [menu]
to return to the main menu.
Tailoring performance
M O V E M E N T
The MAC 250 Krypton provides the three menus with options for optimizing movement to suit different
applications.
•
, the pan and tilt invert menu, allows you to swap the pan and tilt channels (
PA TI
movement (
P
ANEL
), and invert tilt movement (
P IN V >O N
). These options can be useful in situations
TI N V> ON
Control Panel
>
), invert pan
S W AP
O N
11