Installing The Sound And Slope Decals; Installing Rear Weight - Toro Groundsmaster e3200 Operator's Manual

16
Installing the Sound and
Slope Decals
For Machines in
CE/UKCA-Compliant Countries
Parts needed for this procedure:
1 Sound decal
1 Slope decal
Procedure
If you use this machine in a country that complies to
CE or UKCA standards, apply the sound and slope
decals as follows:
•
Sound decal: Apply in the area near the serial
plate as shown in Figure
•
Slope decal: Perform the following steps to install
the decal:
1. Use the following table to determine which
slope-decal letter is applicable for your
equipped attachments:
Attachment
Total Number of
Model Number Batteries Installed
11 or 13
31890 or 31891
15 or 17
*Meets the required slope standard when equipped with the
appropriate amount of rear weight as detailed in this Operator's
Manual.
2. Peel the appropriate slope decal from the
backing and discard the remaining decals.
3. Apply over the area of the warning decal as
shown in Figure
Important:
Ensure that the application surfaces
shown in Figure 14 are clean and dry before you
apply the decals.
14.
Slope Decal*
C
C
14.
1. Slope decal
2. Warning decal
17

Installing Rear Weight

Parts needed for this procedure:
Weight (amount varies per your battery configuration)
Procedure
The machine is shipped with 2 weights (19 kg or 42
lb). If your machine is equipped with 11 batteries
or will be equipped with 13 batteries, perform the
following steps to install the 2 weights to the bumper:
Note:
For machines that will be equipped with 15
or 17 batteries, refer to the Energy Expansion Kit
Installation Instructions for rear weight information.
1. Loosen the hardware
the weight lock rod to the bumper.
24
Figure 14
3. Serial plate
4. Sound decal
(Figure 15) that secures
g469247