Figure 10
1. Cover
2. Nylock nut
3. Washer
2.
Remove the nylock nut and washer from the
steering shaft.
Note:
Ensure that the foam collar remains on
the steering shaft
3.
Slide the steering wheel and washer onto the
steering shaft
(Figure
4.
Use the nylock nut to secure the steering wheel
to the shaft. Tighten the nylock nut to 27 to 35
N∙m (20 to 26 ft-lb).
5.
Mount the cover to the steering wheel
10).
4. Steering wheel
5. Foam collar
(Figure
10).
10).
(Figure
9
Installing the Bumper
Parts needed for this procedure:
1
Bumper
2
Bolt (3/8 x 2-3/4 inches)
4
Bolt (3/8 x 3-1/4 inches)
6
Nut (3/8 inch)
Procedure
1.
Remove the bumper from the shipping skid.
2.
Remove and retain the 2 bolts (3/8 x 2-3/4
inches) and 2 nuts (3/8 inch) that secure the rear
battery tray to the frame
g307379
1. Nuts (3/8 inch)
3.
Loosely secure the upper area of the bumper
to the machine frame using 4 bolts (3/8 x 3-1/4
inches) and 4 nuts (3/8 inch) as shown in
12.
21
(Figure
11).
Figure 11
2. Bolts (3/8 x 2-3/4 inches)
g477675
Figure