Table of Contents
Advertisement
Note:
You can adjust the handle height by installing the
handle bolt and knob through a different set of holes.
4. Slide the upper handle section ends over the lower
handle so that the sections nest together (Fig. 3).
5
2
Figure 3
1. Cables
2. Lower handle
3. Upper handle
5. Make sure that the cables are routed below and behind
the lower handle as illustrated in Figure 3.
6. Secure the upper handle to the lower handle using two
contoured handle bolts and two knobs (Fig. 3).
Installing the Starter Rope
Pull the starter rope through the rope guide on the handle
(Fig. 4).
Figure 4
1. Rope guide
Note: To make the rope easier to install, squeeze the
control bar on the handle.
4
3
1
m–4204
4. Contoured handle bolt
(only one shown)
5. Knobs
210
2. Starter rope
Installing the Discharge Tunnel
Plug
1. Stop the engine and wait for all moving parts to stop.
2. Open the discharge door by moving it rearward
(Fig. 5).
1. Discharge door handle
3. Hold the discharge door handle to prevent the
spring-loaded door from closing while you insert the
plug.
4. Rotate the plug clockwise slightly while inserting it
(Fig. 5).
Make sure that the arrow on the plug decal points
upward.
5. Push the plug all the way in until the spring clip on the
bottom of the plug clicks into place (Fig. 6).
1. Spring clip
6. Release the discharge door handle to lock the top of
the plug.
8
1914
Figure 5
2. Plug (rotated clockwise)
1915
Figure 6
Advertisement
Table of Contents
