Figure 3
1. Locknut
2. Fuel tank retainer
3. Plastic clips
4. Fuel tank
2. Hook the plastic clips on the front of the fuel tank onto
the fuel tank bracket (Fig. 3).
3. Secure the fuel tank to the tank base with the two
self-tapping screws (Fig. 3). Do not overtighten the
screws.
4. Hook the fuel tank retainer onto the rear of the fuel
tank, and slide the end of the retainer into the hole in
the fuel tank bracket (Fig. 3).
5. Secure the retainer to the tank bracket with a locknut
(Fig. 3). Do not overtighten the locknut.
6. Remove the red cap from the end of the fuel line and
from the end of the elbow fitting on the fuel tank
(Fig. 4).
Figure 4
1. Fuel line clamp
2. Fuel line
7. Slide the end of the fuel line onto the elbow fitting
(Fig. 4).
8. Secure the fuel line in place with the fuel line clamp
(Fig. 4).
m-2942
5. Fuel tank bracket
6. Tank base
7. Self-tapping screws
m-2943
3. Elbow fitting
Installing the Air Cleaner Cover
1. Insert the bottom tabs of the air cleaner cover into the
slots (Fig. 5).
Figure 5
1. Slots
2. Tabs
2. Rotate the cover upward and snap it into place (Fig. 5).
Installing the Discharge Tunnel
Plug
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Fig. 6). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
Figure 6
1. Discharge door handle
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Fig. 6).
Note: Ensure that the arrow on the plug decal points
upward.
9
m-196
3. Cover
1
2
m-1914
2. Plug rotated clockwise