Table of Contents
Advertisement
(closest to the board). When connected correctly, the boards are on the same level.
9. Reassemble the boards and the device body than tighten the screws.
Check that the battery and its cables are not clamped. When installed properly, the
boards stand �rmly on all guides and do not stagger. Holding the boards together with
the back lid, turn the device over. The SIM card slot, power, and Ethernet sockets should
match accurately and �t the corresponding sockets, and the power button should not
be stuck.Change the information about input voltage on the device body to avoid
incorrect power connections in the future. Use the special bundled sticker with the
instruction included in the set.
10. Connect the power and Ethernet cable to the appropriate sockets.
11. Switch on the power source to the hub or range extender.
Do not connect the power cable with a voltage that exceeds the acceptable input
voltage of 12–24V PSU for Hub 2 / Hub 2 Plus / ReX 2.
12. Switch on the device by holding the power button for 2 seconds.
Advertisement
Table of Contents
Need help?
Do you have a question about the Hub 2 and is the answer not in the manual?
Questions and answers