Pre-Installation Check - Huawei LUNA2000-7-S1 User Manual

LUNA2000-(7, 14, 21)-S1
User Manual
● Slowly push or move battery packs to prevent damage and collision.
● To prevent battery packs from falling off, start the pallet truck or forklift after
● When moving batteries, do not remove protective components such as
● Exercise caution when moving batteries to prevent bumping and ensure
● Install and secure batteries horizontally from the bottom up and from left to
● When connecting batteries, ensure that the spring washer on the screw is
● Install and secure batteries horizontally from the bottom up and from left to
● Ensure that the power circuit breaker is OFF before installing batteries.
● Keep the battery loop disconnected during installation and maintenance.
● Do not use a damaged battery (such as damage caused when a battery is
● Before installing a battery pack, check that its enclosure is not deformed or

4.1 Pre-installation Check

Checking Outer Packaging
Before unpacking the ESS, check the outer packaging for damage, such as holes
and cracks, and check the ESS model. If any damage is found or the model is not
what you requested, do not unpack the ESS and contact your vendor as soon as
possible.
Issue 01 (2024-03-27)
CA UTION
confirming that battery packs are securely bound.
protective covers or waterproof caps from battery terminals.
personal safety.
right to prevent falling over due to imbalance.
leveled, that the protruding part of the terminal on the cable faces outwards,
and that the cable is intact.
CA UTION
right to prevent falling over due to imbalance.
NO TICE
dropped, bumped, bulged, or dented on the enclosure), because the damage
may cause electrolyte leakage or flammable gas release. In the case of
electrolyte leakage or structural deformation, contact the installer or
professional O&M personnel immediately to remove or replace the battery. Do
not store the damaged battery near other devices or flammable materials and
keep it away from non-professionals.
damaged.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installing the ESS
45