IBM eServer xSeries 255 Option Installation Manual page 69

3. Remove the air baffle:
a. Pull out the two plastic fasteners on the front of the air baffle.
Note: Do not remove the fasteners from the air baffle.
b. Grasp the handle on the air baffle; then, lift the air baffle from the server.
Fasteners
4. Determine the socket where the microprocessor is to be installed.
5. Install a VRM in the corresponding VRM connector (see Table 4 on page 55 for
locations):
a. If you are installing a VRM for microprocessor 3 or 4, remove the
memory-board assembly:
1) Open the release latches located on both ends of the memory-board
assembly.
2) Lift up on the memory-board assembly and remove it from the server.
Air baffle
Handle
Chapter 2. Installing options
57