IBM eServer xSeries 255 Option Installation Manual page 44

10. Disconnect the internal cables from the front of the system board, near the
11. If you have not yet installed a RAID or SCSI adapter, install it now. Otherwise,
12. Disconnect the signal and power cables that are attached to the standard
32
IBM xSeries 255 Type 8685: Option Installation Guide
8. Unlock the metal-hinge latch that secures the shuttle assembly in place. Then,
slide the shuttle assembly toward the rear of the server, approximately 10 cm
(4 in.).
Shuttle latch
9. Disconnect the internal IDE signal cable from the IDE system-board connector.
Disconnect the diskette-drive signal cable and front-fan signal cable from the
corresponding system-board connectors. See "System-board internal cable
connectors" on page 5 for cable locations.
center fans. See "System-board internal cable connectors" on page 5 for cable
locations.
continue with the next step. See "Installing an adapter" on page 19 and your
RAID or SCSI adapter option documentation for additional information about
installing a RAID or SCSI adapter in your server and connecting the SCSI
cables to a RAID or SCSI adapter.
SCSI backplane.