Swapping The Home City Time And Dual Time; Alarm; Using Casio Watches To Configure Alarm Settings; Configuring Alarm Settings - Casio 3552 Operation Manual

4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to set the minute setting.
You can change the setting in 15-
●
minute increments.
6.
Press (A) to complete the setting
operation.
Swapping the Home City
Time and Dual Time
1.
Enter the Dual Time Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
This swaps the Home City time and Dual
Time.
Before swapping After swapping
Dual Time Current location time
Current location time
Note
This function comes in handy when
●
you need to move to another time
zone. For details about how to use it,
go to the section below.
Moving to Another Time Zone
l
Watch Operation Guide 3552
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
An alarm will not sound if the battery is low.
●
Using CASIO WATCHES to
Configure Alarm Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set alarms.
Configuring Watch Settings
l

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the alarm you want to
configure is displayed.
Dual Time
3.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.

Alarm

Alarm number
Alarm time
Alarm hour
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to exit the setting screen.
(alarm) is shown on the display
●
while an alarm is turned on.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
The watch will automatically return
●
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Testing the alarm
●
In the Alarm Mode, hold down (D) to sound the
alarm.
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
18