Measuring a Split Time or Lap
Time
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
Each press of (A) displays the time
●
elapsed from the start of the stopwatch
operation up to that point (split time) and
the elapsed time for a specific segment
(lap time).
D
Start
A
Split/lap
D
Stop
Split times and lap times are both
●
displayed at the same time. Lap and
split times up to the one hour are shown
in 1/100-second units. Subsequent
measurements after one hour are
shown in 1-second units.
[SPL]: Split time
[LAP]: Lap time
First hour
After first hour
Time Number*
Time Number*
Seconds
Minutes
Hours
Seconds
1/100 seconds
* [F] is displayed for the final time
number when an elapsed time
measurement operation is stopped.
3.
Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 3552
Viewing the Current Time
While in the Stopwatch Mode
Pressing (A) while the stopwatch is reset to all
zeros causes the current time to appear in the
lower section of the screen. Press (A) again to
return to the normal stopwatch display.
Measurement
Viewing Measured Time Data
Viewing Saved Data
You can use the operation below to view split
times and lap times.
1.
Enter the Recall Mode.
Navigating Between Modes
l
This causes the latest measurement
●
number and date to appear.
Minutes
Minutes
Seconds
Measurement
Current time
Record number
Measurement date
Measured time
2.
Press (A) to cycle through measurement
numbers.
Each time you press (A), the next older
●
measurement number appears.
A
A
A
A
3.
Press (D) to display the lap time of the
currently displayed lap number.
[LAP]: Lap time
[SPL]: Split time
Note
A record of the measured data is
●
created and assigned a number for
each measurement operation (from
start to stop).
21