Step Reminder; Clearing A Step Reminder Alert Indicator; Enabling/Disabling Step Reminder; Causes Of Incorrect Step Count - Casio 3552 Operation Manual

Step Reminder

If the watch determines that you have not
walked for a preset amount of time, it will
sound a tone and display a flashing Step
Reminder indicator. If the watch performs this
Step Reminder alert operation, get up and
walk for five minutes to clear it.
Step Reminder
Clearing a Step Reminder
Alert Indicator
To clear the step reminder alert indicator
([STEP!]), press any button besides (B).
Step Reminder
Watch Operation Guide 3552
Enabling/Disabling Step
Reminder
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the current step reminder
setting ([ON] or [OFF]) to flash on the
display.
3.
Press (D) to toggle Step Reminder
between enabled and disabled.
[ON]: Enabled
[OFF]: Disabled
4.
Press (A) to complete the setting
operation.
Causes of Incorrect Step
Count
Any of the conditions below may make proper
counting impossible.
Walking while wearing slippers, sandals, or
●
other footwear that encourages a shuffling
gait
Walking on tile, carpeting, snow, or other
●
surface that causes a shuffling gait
Irregular walking (in a crowded location, in
●
a line where walking stops and starts at
short intervals, etc.)
Extremely slow walking or extremely fast
●
running
Pushing a shopping cart or baby stroller
●
In a location where there is a lot of vibration,
●
or riding on a bicycle or in a vehicle
Frequent movement of the hand or arm
●
(clapping, fanning movement, etc.)
Walking while holding hands, walking with
●
a cane or stick, or engaging in any other
movement in which your hand and leg
movements are not coordinated with each
other
Normal daily non-walking activities
●
(cleaning, etc.)
Wearing the watch on your dominant hand
●
Walking for 18 seconds or less
●

Other Settings

This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the current step reminder
setting ([ON] or [OFF]) to flash on the
display.
3.
Press (C) nine times.
This causes [KEY♪] or [MUTE] to flash on
the display.
4.
Press (D) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Note that alarm and timer tones will still
●
sound even while the operation tone is
muted.
25