Casio 3552 Operation Manual page 29

Auto Time Correction by
Bluetooth Connection (Time
Correction)
Q1
When does the watch correct its
time?
The watch will connect with the phone and
perform auto time correction at around 12:30
a.m., 6:30 a.m., 12:30 p.m. and 6:30 p.m. The
connection is automatically terminated after
auto time correction is complete.
Q2
Auto time correction is not performed
at a scheduled time.
Is auto time correction not being
performed according to its normal
schedule?
Note that auto time correction is not
performed for 24 hours after swapping of
the Home Time and World Time, or after
the time setting is corrected manually on
the watch. Auto time correction will
resume 24 hours after either of the above
operations is performed.
Is auto time adjustment enabled?
Auto time adjustment will not be
performed at the scheduled times unless
it is enabled. Enable auto time
adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
Watch Operation Guide 3552
Q3
The watch does not connect with a
phone and correct its time when I
press (D).
A time correction operation will not start if you
press (D) while the remaining countdown time
is 30 seconds or less. Stop the timer operation
and then press (D) again.
Q4
Time is not displayed correctly.
If your phone is unable to receive a signal
because you are outside its service range or
for some other reason, the watch may not be
able to display the correct time. If this
happens, connect the phone to its network
and then correct the time setting.
Pedometer
Q1
Displayed step count is not correct.
While the watch is on your wrist, it may detect
non-step movements and count them as
steps.
Pedometer
l
Also, step count problems can also be caused
by how the watch is being worn and abnormal
arm movement while walking.
Counting Steps
l
Q2
The step count does not increase.
To avoid miscounting non-walking
movements, the step count or distance value
is not displayed for about 18 seconds after you
start to walk.
It appears only after you have continued
walking for about 18 seconds, with the number
of steps you took during the first 18 seconds
included in the total.
Q3
[ERR] appears when counting steps.
[ERR] (error) indicates that sensor operation
is disabled because of sensor or internal
circuitry malfunction.
If the indicator remains on the display for more
than three minutes or if it frequently appears,
it could indicate a faulty sensor.
Contact a CASIO service center or your
original retailer.
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
The alarm's settings may not be configured.
Configure the alarm settings.
Configuring Alarm Settings
l
Q2
The hourly time signal does not
sound.
The hourly time signal may be disabled.
Enable the hourly time signal.
Enabling the Hourly Time Signal
l
29