Reboot; Warm Boot; Cold Boot - Honeywell LXE MX7 User Manual

Reboot

When the Windows desktop is displayed or an application begins, the power up (or reboot) sequence is complete.

Warm Boot

Start > Run
In warm boot, the MX7 reloads the operating system and CAB files from the internal SD card and the preserved registry is also
reloaded. Anything not saved or preserved to the registry is lost.
Hold down the Power key for 15 seconds until the display blanks, then release the key.
Or, using the input panel,
Tap Start > Run and type WARMBOOT.EXE or WARMBOOT. This command is not case sensitive. Tap the OK button. This
process takes less than 15 seconds. Temporary data not saved is lost.
Note: There may be slight delays while the wireless client connects to the network, re-authorization for voice-enabled
applications completes, Wavelink Avalanche management of the MX7 startup completes, or Bluetooth relationships
establish or re-establish.

Cold Boot

Start > Run
The Cold Boot function reboots the device, erases all registry data, and user-specified settings. The factory default settings are
restored when the MX7 powers on again.
Tap Start > Run and type COLDBOOT.EXE or COLDBOOT. This command
Note: Because of the extreme nature of cold boot, Honeywell recommends using this command only as an emergency (or
when instructed to do so as part of a specific MX7 procedure).
1
The text typed in the text box can be upper or lower case or a combination of upper and lower case letters.
2-16
1
is not case-sensitive . Tap the OK button.