Grizzly G0962 Manual page 66

4. Insert lower set of holes on spreader/riving
knife into bracket slot, and tighten lock lever
to secure spreader (see Figure 49).
Note: DO NOT insert upper set of holes on
spreader into bracket slot. Doing so will result
in improper installation of blade guard.
Spreader
Figure 49. Lock lever used to secure spreader/
riving knife.
5. Re-install table insert (see Table/Dado Insert
Adjustment on Page 76).
6.
Tug spreader upward to verify it is locked.
7.
Push guard lever toward front of saw.
8.
Insert rear pin on blade guard into rear slot of
spreader (see Figure 50), then push down on
blade guard assembly so forward pin slides
into forward slot of spreader.
Pin
Figure 50. Example of blade guard installation.
-36-
Bracket Slot
Lock Lever
Guard Lever
9. Push guard lever toward rear of saw, locking
blade guard.
10. Tug upward on blade guard assembly to
verify that it is locked into spreader.
— When properly installed, blade guard
should be set up similarly to Figure 51. It
should pivot freely up and down and return
to table in resting position. It should also
swing up high enough to accommodate
workpiece.
Figure 51. Blade guard installed.
11. Swing right side of blade guard up and out of
the way.
12. While lifting up on right spreader pawl, place
a straightedge against blade and spreader,
making sure straightedge does not touch a
blade tooth.
When properly aligned, spreader/riving
knife will be in "Alignment Zone," shown in
Figure 52, and will be parallel with blade.
Spreader or
Riving Knife
Blade
Figure 52. Spreader in "Alignment Zone".
Model G0962A40 (Mfd. Since 07/22)
Alignment
Zone
Straightedge