Grizzly G0962 Manual page 11

16. Install saw blade as instructed in Blade
Installation on Page 34.
17. Install table insert in table opening (see
Figure 21). Check to make sure it is flush
and adjust if necessary (see Table/Dado
Insert Adjustment on Page 76).
Figure 21. Example of standard table insert
installed.
18. Place fence on front fence rail, as shown in
Figure 22. Press handle down to lock fence
in position.
Front
Fence
Rail
Figure 22. Example of fence installed on front
rail.
Model G0962 (Mfd. Since 02/24)
19. Using blade height handwheel, raise blade
1–2 inches.
20. Turn blade tilt handwheel until blade tilt
indicator on front of machine points to 0° on
blade angle scale.
21. Lift fence handle and slide fence so it lightly
touches right side of blade (see Figure 23).
Do not lock fence at this time.
22. Nudge fence rail so zero mark of scale (on
right) lines up with cross-hair in fence scale
window (see Figure 23).
Fence Lightly
Touching Blade
Fence
Figure 23. Example of fence scale calibration.
23. Fully tighten hex nuts from Step 13 to secure
front fence rail.
Fence Scale
Window
-11-