CyberPower PRL1500RT2UC User Manual page 16

LCD OPERATION GUIDE (continued)
Item
Battery Change Date
Schedule Test – On
Startup
Schedule Test –
Frequency
Date and Time
Power Meter Reset
IP Access
IP Address
Subnet Mask
Gateway
Wiring Fault
Firmware Update*
*Only displayed in
Standby Mode
Back to Default
Default

---/---- Month/Year

Yes
No

No

Never

Every 1 week

Never Every 2 weeks

Every 3 weeks

Every 4 weeks

Year/Month/Day
----/--/-- --:--
Hour:Minute

Yes
No

No

DHCP
DHCP

Manual IP Setup

Auto-sensing
Auto-sensing

Manual Key-in

Auto-sensing
Auto-sensing

Manual Key-in

Auto-sensing
Auto-sensing

Manual Key-in

Enable
Disable

Disable

Yes
No

No

Yes
No

No
Option
Optional setup information for users to record the
installation date of battery pack. Reset the data
when replacing new battery pack.
If Yes is selected, the UPS will perform a Self Test
every time on startup.
Select the amount of time that the UPS will
perform Self Test periodically after startup.
Set the Date and Time for use in data/event logs.
Select Yes to reset the value of Load Energy in
Status Menu.
Select the way to access the IP/Subnet
Mask/Gateway. This shows "No Web Device" when
no RMCARD is installed.
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows "No Web Device" when no RMCARD is
installed.
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows "No Web Device" when no RMCARD is
installed.
Change the IP Access setting to manual IP Setup
and then this item can be adjusted manually. This
shows "No Web Device" when no RMCARD is
installed.
Select Enable to perform auto checking of utility
wiring and ground.
Select Yes to update the firmware of UPS in
Standby Mode.
Select Yes to restore the UPS factory default
settings.
15
Description