Introduction; Symbols; About This Manual - Scanprobe Maxprobe User Manual

Introduction

The Scanprobe Techniques Limited Maxprobe range are designed as CCTV pipeline survey
and inspection systems, suitable for use in non-hazardous locations, designed to survey and
inspect pipelines ranging from 50mm to 300mm (2" to 12") in most common residential,
commercial, and industrial areas.
Included in the Maxprobe range are:
•
The Maxprobe System fitted with 60m pushrod.
•
The Maxprobe XL system fitted with 100m pushrod.
•
The Maxprobe 120 system fitted with 120m pushrod.
•
The Maxprobe Lite system fitted with 40m pushrod.
The Maxprobe range is not suitable for use in mines susceptible to firedamp, nor in
hazardous areas with explosive dust or gas atmospheres, due to the explosive hazards
associated with these locations. If there is a potential to encounter explosive conditions
during the planned survey or inspection, equipment designed for ATEX operations should be
used. Please contact Scanprobe Techniques Ltd, or one of their authorised agents, for
further information on products that are suitably certified for ATEX use.

Symbols

Throughout this document, symbols have been used to highlight points to note.
Warning:
This symbol highlights risks where death or injury may occur.
Caution:
This symbol highlights risks where damage to property or to the Maxprobe
System could occur.
Note:
This icon is used highlight areas with special requirements.
Maintenance:
This symbol highlights maintenance and cleaning instructions.

About This Manual

This User Manual provides instructions and important information which must be adhered to
when using the Maxprobe pipeline inspection system.
Warning:
When operating the Maxprobe System, it is essential that you thoroughly read
and understand this user manual first. It contains important information and
warnings that help to avoid hazards, increase the reliability, and extend the life of
the system and its components. Follow all the instructions carefully and observe
all warnings to avoid putting yourself or other users of the system at risk and to
prevent damage to the system.
Maxprobe User Manual
Version 2.0
22 November 2023
5