Troubleshooting - Scanprobe Maxprobe User Manual

Maxprobe User Manual
44

Troubleshooting

Problem
The device does not
power up.
The device does not
power up when
power button is
pressed. The power
button does not light
up.
Buzzer sounds and
the LED is flashing
red on the rear of the
CCU
Battery does not
charge
CCU screen is blank
CCU shuts off
Blue Screen
displayed on CCU
Version 2.0
22 November 2023
Cause
Power button was
Press the power button.
not pressed.
Battery is flat Charge the battery.
Return the CCU to your approved service
Battery is faulty
center to have the battery replaced.
Battery is critically
Charge the battery.
low
Charger not Check all cables and connections are
connected connected and secure. Charge the battery.
Check the charger is plugged into a suitable
Charger is
and available power source. Charge the
unpowered
battery.
Vehicle charger Unplug the vehicle charger from the CCU
lead fuse has and the vehicle. Unscrew the vehicle
blown charger connector and replace the fuse.
Return the CCU to your approved service
Battery is faulty
center to have the battery replaced.
System is not
Press the power button.
powered
Battery is depleted Charge the battery.
No camera Fit a Maxprobe 44mm Camera
Dirt in the camera Clean the camera connector and refit the
connector camera.
Check the cable between the coiler and CCU
No cable between
is present and both ends are securely
the coiler and CCU
connected.
Check the connector pins on the CCU and
coiler for damage. Return the system to your
Damaged connector
approved service center to have the
damaged connector replaced.
Check all cables for damage. Order a
Damaged cable replacement cable from your approved
service center.
Check the pushrod for damage. Return the
Damaged pushrod system to your approved service center for a
cutback or a re-rod.
Solution