After Use, Care And Maintenance; Roller Guide; Connector And Cable Care; Cleaning And Maintenance - Scanprobe Maxprobe User Manual

Maxprobe User Manual
38

After Use, Care and Maintenance:

Roller guide

The roller guide is an integral part of the coiler which will increase the longevity of the push
rod if maintained correctly. If the roller stops rotating it will start to wear out which will
significantly increase the chance of wear to the push rod jacket. Please clean all parts
thoroughly with clean water if rotation is hampered or stops.
How to remove roller parts for replacement or cleaning:

Connector and cable care

Connectors and cables are an integral part of any system, taking good care of these will
allow the electrical signals to reliably transmit. It is therefore essential to check the cable,
connectors, and interfaces after each inspection by following these simple steps:
•
Ensure the system is disconnected from the power supply.
•
Check connector pins are all intact, clean and check no visible damage is
present on the cable.
•
Check O-rings for damage and replace if necessary (grease regularly).
•
If damage is identified, contact Scanprobe Techniques or its authorised agents.

Cleaning and Maintenance

Caution: Risk of Damage
Check to make sure there are no external devices remaining plugged into the
front connectors, and that there are no objects on the keyboard, before closing
the keyboard. Closing the lid while devices remain plugged in may damage the
Version 2.0
22 November 2023