Espressif ESP32-S2 Programming Manual page 1145

Chapter 2. API Reference
CONFIG_ESP_WIFI_SLP_DEFAULT_MAX_ACTIVE_TIME
Maximum keep alive time
Found in: Component config
The maximum time that wifi keep alive, unit: seconds.
Range:
• from 10 to 60 if
Default value:
• 10 if CONFIG_ESP_WIFI_SLP_IRAM_OPT
CONFIG_ESP_WIFI_FTM_ENABLE
WiFi FTM
Found in: Component config
Enable feature Fine Timing Measurement for calculating WiFi Round-Trip-Time (RTT).
Default value:
• No (disabled)
CONFIG_ESP_WIFI_FTM_INITIATOR_SUPPORT
FTM Initiator support
Found in: Component config
Default value:
• Yes (enabled) if
CONFIG_ESP_WIFI_FTM_RESPONDER_SUPPORT
FTM Responder support
Found in: Component config
Default value:
• Yes (enabled) if
CONFIG_ESP_WIFI_STA_DISCONNECTED_PM_ENABLE
Power Management for station at disconnected
Found in: Component config
Select this option to enable power_management for station when disconnected. Chip will do modem-
sleep when rf module is not in use any more.
CONFIG_ESP_WIFI_EXTERNAL_COEXIST_ENABLE
WiFi External Coexistence
Found in: Component config
If enabled, HW External coexistence arbitration is managed by GPIO pins. It can support three types of
wired combinations so far which are 1-wired/2-wired/3-wired. User can select GPIO pins in application
code with configure interfaces.
This function depends on BT-off because currently we don't support external coex and internal coex
simultaneously.
Default value:
• No (disabled)
Espressif Systems
> Wi-Fi > CONFIG_ESP_WIFI_SLP_IRAM_OPT
CONFIG_ESP_WIFI_SLP_IRAM_OPT
> Wi-Fi
> Wi-Fi > CONFIG_ESP_WIFI_FTM_ENABLE
CONFIG_ESP_WIFI_FTM_ENABLE
> Wi-Fi > CONFIG_ESP_WIFI_FTM_ENABLE
CONFIG_ESP_WIFI_FTM_ENABLE
> Wi-Fi
> Wi-Fi
1134
Submit Document Feedback
Release v4.4