Espressif ESP32-S2 Programming Manual page 1255

Chapter 2. API Reference
ESP_ERR_ULP_BRANCH_OUT_OF_RANGE
with BX)
ESP_ERR_OTA_BASE (0x1500): Base error code for ota_ops api
ESP_ERR_OTA_PARTITION_CONFLICT
partition
ESP_ERR_OTA_SELECT_INFO_INVALID
ESP_ERR_OTA_VALIDATE_FAILED
ESP_ERR_OTA_SMALL_SEC_VER
firmware.
ESP_ERR_OTA_ROLLBACK_FAILED
and hence rollback is not possible
ESP_ERR_OTA_ROLLBACK_INVALID_STATE
pending validation state (ESP_OTA_IMG_PENDING_VERIFY), essentially first boot of firmware image post up-
grade and hence firmware upgrade is not possible
ESP_ERR_EFUSE (0x1600): Base error code for efuse api.
ESP_OK_EFUSE_CNT (0x1601): OK the required number of bits is set.
ESP_ERR_EFUSE_CNT_IS_FULL
ESP_ERR_EFUSE_REPEATED_PROG
bidden.
ESP_ERR_CODING (0x1604): Error while a encoding operation.
ESP_ERR_NOT_ENOUGH_UNUSED_KEY_BLOCKS
ESP_ERR_DAMAGED_READING
damage read data. This error is internal to the efuse component and not returned by any public API.
ESP_ERR_IMAGE_BASE (0x2000)
ESP_ERR_IMAGE_FLASH_FAIL (0x2001)
ESP_ERR_IMAGE_INVALID (0x2002)
ESP_ERR_WIFI_BASE
ESP_ERR_WIFI_NOT_INIT
ESP_ERR_WIFI_NOT_STARTED
ESP_ERR_WIFI_NOT_STOPPED
ESP_ERR_WIFI_IF (0x3004): WiFi interface error
ESP_ERR_WIFI_MODE
ESP_ERR_WIFI_STATE
ESP_ERR_WIFI_CONN
ESP_ERR_WIFI_NVS (0x3008): WiFi internal NVS module error
ESP_ERR_WIFI_MAC (0x3009): MAC address is invalid
ESP_ERR_WIFI_SSID
ESP_ERR_WIFI_PASSWORD
ESP_ERR_WIFI_TIMEOUT
ESP_ERR_WIFI_WAKE_FAIL
ESP_ERR_WIFI_WOULD_BLOCK
ESP_ERR_WIFI_NOT_CONNECT
Espressif Systems
(0x1205): Branch target is out of range of B instruction (try replacing
(0x1501): Error if request was to write or erase the current running
(0x1502): Error if OTA data partition contains invalid content
(0x1503): Error if OTA app image is invalid
(0x1504): Error if the firmware has a secure version less than the running
(0x1505): Error if flash does not have valid firmware in passive partition
(0x1506): Error if current active firmware is still marked in
(0x1602): Error field is full.
(0x1603): Error repeated programming of programmed bits is strictly for-
(0x1606): Error. Burn or reset was done during a reading operation leads to
(0x3000): Starting number of WiFi error codes
(0x3001): WiFi driver was not installed by esp_wifi_init
(0x3002): WiFi driver was not started by esp_wifi_start
(0x3003): WiFi driver was not stopped by esp_wifi_stop
(0x3005): WiFi mode error
(0x3006): WiFi internal state error
(0x3007): WiFi internal control block of station or soft-AP error
(0x300a): SSID is invalid
(0x300b): Password is invalid
(0x300c): Timeout error
(0x300d): WiFi is in sleep state(RF closed) and wakeup fail
(0x300e): The caller would block
(0x300f): Station still in disconnect status
Submit Document Feedback
(0x1605): Error not enough unused key blocks available
1244 Release v4.4