Intel SYSTEM 310 Configuration Manual page 44

INDEX
012B memory board, iSBC
capacity of, 3-3, 3-4
combinations using, 1-3,
3-1, 3-3, 3-4
recommended addresses,
3-3, 3-4, 3-5, 3-6
revision differences, 3-1,
-l, -2. See
also Jumper settings
056 memory board, iSBC
capacity of, 3-5, 4-3
combinations using, 1-3,
3-4, 3-5, 4-3
recommended addresses,
3-5, 3-5. See also Jumper
settings
304 memory board, iSBC
capacity of, 1-3, 3-4
combinations using, 1-3,
3-4, 3-5
jumper settings, 2-1
recommended addresses,
3-4, 3-5. See also Jumper
settings
86/30 processor board R M,
iSBC
capacity of, 3-4
jumper settings, 3-4
recommended addresses,
3-3, 3-4. See also Jumper
settings
ddresses. See Individual
boards, listed by number.
ddressing, on block boundaries.
See Boundaries
Battery backup, 3-3, 3-8
Board placement. See Removing
and installing
Boundaries, 2-1, 3-6, 4-4
Cables. See Removing and
installing
Combinations of tested memory
boards. See Individual boards,
listed by number
Ending addresses. See individual
boards, listed by number
Expanding memory. See
Memory
Firmware, contents and location,
1- 1
Installing and removing.
See Removing and installing
Intelligent communications
controllers, Location of, 1-2
Interrupts, 3-3, 3-8, 4-6
I/O address selection.
See Status/error register
iSBC. See Individual boards,
listed by number
Jumper settings,
address select, 3-3, 3-4,
3-5, 3-6, 4-3
battery backup, 3-8
differences between 012B
board versions, 3-1, -l,
-2
half or full size memory,
3-6, 3-7
jumper-selectable
parameters, 3-1, 4-1
interrupt on parity error,
3-8, 4-6
I/O address select, 3-7, 3-8
segment or page select,
3- 6, 4-4
status/error register, 4-4,
4- 5. See also 304
memory board, 86/30
processor board R M
Masking off memory, 3-6
Megabyte page select.
See Boundaries
Memory,
capacity, 1-2, 2-1
rules for expanding, 1-2.
See also Individual boards,
listed by number
Index-1