Disconnecting The Cables; Installing The Serial And Parallel Port Cables - Intel SYSTEM 310 Configuration Manual

Removing and Installing Memory Boards
System 310
2. Turn the chassis so that the back panel is facing you.
3. Remove the four Phillips screws holding the back panel to the
chassis. Save these screws and remember where they came
from so you can reinsert them later.
4. Tilt the top of the back panel toward you and lift it out of the
track at the bottom of the chassis. Be careful not to pull the
back panel toward you so far that you disconnect the cables
prematurely.
DISCONNEC ING HE CABLES
Figure 5-1 shows the chassis with the back panel ajar and identifies
the cables plugged into the processor board. The smaller one on the
left is the serial port cable, and the larger one on the right is the
parallel port cable. To remove any memory board, you must
disconnect these cables as described in the next three steps.
BACK
PANEL
PA ALLEL PO T
CONNECTO
AND CABLE
Figure 5-1. Installing the Serial and Parallel Port Cables
fooio
5-2